Subject | Text |
Altec Lansing Sub of computer speakers | My wife accidentally shorted the input line which has caused a 60 cycle hum that increases when the |
| [url=http://www.opentip.com/products/Altec_Lansing_inMotion_iMc_Portable_speakers_for_iPod_Watt_tota |
|
Sony SS-CR64 Surround Sound Speaker System | I need the instructions for the Surround Sound and Dolby features on this unit. The center speaker |
Sony SS-CR64 Surround Sound Speaker System | I need the instructions for the Surround Sound and Dolby features on this unit. The center speaker |
Emerson MS9920TT speaker problem | I just recently acquired this three-component stereo system, but it has a speaker issue. Signal is |
IM7 Amplifier Board Repair | Hey everybody!
Anyway, I added a subwoofer output to my Altec Lansing IM7 and also added a potent |
hk amplifier low level speaker output | I have a harman kardon avr 130 amp that has a very distorted and low left surround level speaker out |
Yamaha RX-V520 Main Speaker not turning on | Hi,
I have a Yamaha RX-V520 A/V receiver which up until recently worked fine. About a month ago o |
Thanks | Thanks so much for the help. As soon as I get a chance I"m gonna run down to radio shack and pick u |
Sony Amp - The woes continue | Andreas,
Try removing every input and output and see what happens, then add them back one by one |
str-de945 problem | Is the action (or lack thereof) intermittant? If so, it is likely a bad solder joint. The IR sensors |
SONY STR KSL5 Protect Fault | I have a SONY STR KSL5 home cinema system which after about 5 mins shuts off with the word "PROTECT" |
| Here's the parts that I used:
[url=R509 100K Ohm 1W resistor[/url] - got an set on Amazon. I prob |
| yeah! tv still working but, always need to push the reset button in front. otherwise no signal with |
repairing an old sansui amplifier | hello every one ,
new member here and also newby in the electronic repair
i have an old sansui |
Dead Black Diamond BD28WS | Hello to everyone this is my first post here. I have a BD28WS Black Diamond TV. The fault is when I |
Looking for Pioneer VSX-D307 Receiver Service Manual | I'm looking for a service manual (or at least a schematic) for my Pioneer VSX-D307 Receiver.
Anyo |
|
voltage for relay | hi,i have a problem on my yamaha rx-v392 model...i need to know what is the voltage of the relay in |
Re: Onkyo TX-SV535 Amp / Remote Speakers NOT Working | [quote:586d3411be="kayecross"]I can not get the remote speaker button to work on my amp. I have inst |
| Hi again,
By bypassing the main speaker relay everything works great. Does anyone know if this mi |
avr 130 one of the surround outputs is very very low | got a harman kardon avr 130 one of the surround outputs is very very low
when i connected speaker t |
Re: Do this test | Forgot to mention: Keep CD player's volume quite low to keep from exceeding input level rating of yo |
| Protect mode occurs when an overcurrent situation is detected by the power supply in the amplifier. |
Headphone circuit for TV needed. | Hello all. I hope this is the right place for my question. Ok, I have a infrared wireless headphon |
| Blowing speaker protection fuse suggests failure of the power amplifier output transistors. If a DVM |
| Hi,
Few things u can check:
1. Does the set power up?
2. Speakers - are they connected prop |
Siemens Gigaset 4010 Comfort problem | Can make call but can't disconnect (end it.) If I call someone and try to end call only sound is tur |
| I agree with Miguel. if your mixer has PAN controls just turn all of them to the same end so your ch |
AKAI AM-A2 (help) | Hey. I Picked up an ''AKAI AM-A2 model Stereo Integrated Amplifier'' the other day. An electrician s |
| Or check there isn't a speaker/magnet near the T.V.! |